home security systems alarm

g. , based on detected control signals and transmission requests. Each of the above identified elements may be stored in one or more of the previously mentioned memory devices, and corresponds to a set of instructions for performing a function described above. The above identified modules or programs i. e. , sets of instructions need not be implemented as separate software programs, procedures, or modules, and thus various subsets of these modules may be combined or otherwise rearranged in various implementations.

install security system

01.14.2007 | 34 Comments

Outdoor cameras should be weather proof, vandal proof, and come equipped with night vision. Other features might include a built in motion detector. It’s important to buy equipment that can stand up to your local weather conditions, be that extreme heat, cold, or moisture. Cameras are also exposed to anyone who approaches your home, so you should consider how your video feed is protected from vandals smashing the camera. Vandal proof cameras protect the camera lens from damage with a polycarbonate dome cover or metal housing. Just like indoor cameras, consider how videos are stored, when the camera will film, and the quality of the video.

compare home security system

01.14.2007 | 16 Comments

The extended holding structure may be pulled out of the recess hole of the device housing 702 when the device housing 702 slides along a longitudinal direction 812A or a transversal direction 812B, but not when the device housing 702 is pulled by a separation force having a direction perpendicular to a front exterior surface of the device housing 702. Further, the first fastener structure 806 may include a snap fastener configured to lock onto the respective fastener structure 726 of the device housing 702. Once locked onto each other, the snap fastener 806 and the respective fastener structure 726 securely hold the device housing 702 onto the mounting plate 800, thereby onto the wall or doorframe surface to which the mounting plate 800 is mounted. Alternatively, in another example, each of the first and third fastener structures 806 and 808 includes a respective snap fastener configured to lock onto the respective fastener structure 726 or 728. The mounting plate 800 may include an opening 810 configured to let through one or more electrical wires, such as the power supply line and the ground line that can be electrically coupled to the plurality of wire terminals 720 of the doorbell camera 106. In some implementations, in accordance with the process 850 of mounting the doorbell camera 106, the mounting plate 800 is fixed onto an area of the surface where the power supply line and the ground line are located. The power supply and ground lines come out of the surface, pass through the opening 810, and are connected to the plurality of wire terminals 720 located at the rear exterior surface of the doorbell camera 106. The device housing 702 is then mounted onto the mounting plate 800 via the fasteners 806 and 808 and their respective fasteners 726 and 728 located at the rear exterior surface of the doorbell camera 106. The power supply and ground lines are concealed within the opening 810 of the mounting plate 800 and the first recess 724A of the device housing 702. Under these circumstances, the depth of the first recess 724A is configured such that a cumulative depth that sums the depth of the first recess 724A and a depth of the opening 810 is greater than a height of connections formed between the plurality of wire terminals 720 and the power supply and ground lines. By these means, the device housing 720 may be securely mounted onto the mounting plate 800 without being withheld by the connections formed between the plurality of wire terminals 720 and the power supply and ground lines.